NcStar 1 -Inch Scope Adapter with Double Weaver Base (M2RD1)

 (4 customer reviews)

The mounting band is narrow and frail looking. Considering it has two weaver accessory rails, I wonder how it would hold up to real recoil. My reflex sight weighs a little over 4 ounces. Combine that with a flashlight and this little band is going to take a beating on anything with real recoil, or a springer airgun.

The weaver rails seem a bit narrow too. Or perhaps there is a difference between weaver and picatanny specs on width. My Smith and Wesson molded tactical LED fits tightly on my handgun's built-in rail, but on this adapter it has a LOT of play. Perhaps 0.8mm or so. It really rattles around. If your accessories screw on, this won't be a problem. My light however is molded one piece, and has a locking bar, so it depends on a tight fit for alignment and holding power.

I came across this while looking at other stuff and decided that it looked to handy not to have, I've put it on a couple different gun scopes and a shot gun tube, I could buy a couple more but I don't have enough accessories to go around, yet ;) it ended up on the scope of my .223 pump with a relex sight on one side and green laser on the other

After hours of research, this is just about the only one inch tactical scope mount you're going to find. It's a little short for most red dots, but thankfully mine mounted just fine. Taking it outside shooting tomorrow to see if it's sturdy enough to hold zero.
Overall, great little piece of medal.